Large Rolled Decal Instructions: Do Not install in Direct Sunlight.

  1. Your decal is supplied in 3 layers. The decal itself is in between a layer of backing material, and a layer of transfer film.
  2. Your decal has been rolled for shipment. Unroll, and lay flat for 24 hours. To ensure that the decal is properly stuck to the transfer film covering before installing the decal, take a squeegee and press firmly over the whole surface of the face of the decal while it is still laying flat on the table.
  3. Line up decal in desired position, and tape in place with masking tape. Tape all 4 corners, and middle. Make sure decal is firmly in place
  4. Remove masking tape from one side of decal and roll back decal to middle where taped.
  1. Peel back backing material to the middle where taped.
  2. Cut backing material away with scissors or razor knife.
  3. Spray surface of vehicle with a fine mist of water solution. (water optional)
  4. Start application of decal from the center and press firmly with squeegee working your way to the edge of the decal. Work slowly and carefully to work any air bubbles out.
  5. Once first side is applied, remove rest of backing material, spray vehicle with a fine mist of water solution, and work from the center pressing firmly with squeegee to the other edge. (water optional)
  1. Rub over entire decal with squeegee.

FOR 2 PC DECAL SETS: Apply outer decal to vehicle first as per instructions above. To install inner decal, cut around the edges of the decal as close as possible to aid in alignment. Tape in place like above instructions.

Depending on the decal being applied, some trimming may be necessary. If your decal spans door openings, it is recommended to cut the decal prior to applying. Once decal is taped in place, cut decal at door openings, and retape ends. This will keep decal aligned, and allow for easier installation. Once decal touches surface of dry vehicle, IT WILL STICK PERMANANTLY. Not responsible for installation errors. If using water, DO NOT USE TOO MUCH. EXTREME FINE MIST IS ALL YOU NEED! DO NOT INSTALL IN DIRECT SUNLIGHT.

After decal is placed, slowly remove the transfer film. If any of the decal starts to pull up, it has not been applied firmly enough. Press down over the decal again before trying to remove transfer film.

If more water is use than necessary, you may need to wait up to 15 minutes to remove transfer film.

Any small air pockets can be easily removed by first placing a small hole in the bubble with a pin. Then moisten the squeegee edge with water solution and slide the squeegee along the surface of the stripe where the bubble is, working the air towards the hole.

Note 1: Only apply decal to clean surface. Clean with soap and water prior to installation, and make sure area is thoroughly dry. Only apply decals in temperatures greater than 50 Degrees

Note 2: Water solution is roughly 1 liter of water to 1 teaspoon of dish soap.

Please be sure to measure accurately. All of our products are custom made to order, so there are no returns, exchanges or refunds once the product has shipped.

Do not install in direct sunlight.